Engineering, 04.12.2019 20:31 claudiasfandom

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reached. however, the flow can be tripped to a turbulent state by adding roughness to the leading edge of the plate. for a particular situation, experimental results show that the local heat transfer coefficients for laminar and turbulent conditions are:

h lam ( x ) = 1.74 w / m^ 1.5 * k x^ − 0.5

h turb ( x ) = 3.98 w / m^ 1.8 * k x ^− 0.2

calculate the average heat transfer coefficients for laminar and turbulent conditions for plates of length l = 0.1 m and 1 m.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

You know the right answer?

Laminar flow normally persists on a smooth flat plate until a critical reynolds number value is reac...