Engineering, 04.12.2019 04:31 kahnerp6448

8-36 using the batch simulator screen, write a program that will implement the following tank filling and mixing sequence. the start button is pressed to start input pump p1 after 100 gallons (one flowmeter pulse per gallon) input pump p1 stops automatically and the mixer motor starts. o the mixer motor is automatically stopped after 30 seconds, and the input pump p1 is started after an additional 60 gallons are pumped into the tank, the input pump stops and the mixer motor starts. the mixer motor is operated for 20 seconds and stops. o the discharge pump p3 motor is started automatically and runs until the low-level sensor is actuated. the process stops use the following addresses in developing the program start pb : 1/0 stop pb : 1/1 input flowmeter_: 1/5 low-level sensor_ l: 1/3 mixer motor 0: 2/0 oinput pump p1 o: 2/1 discharge pump p3_ o: 2/3 ointernal relay_ b3: 0/0 o ctu c5: 1 o ctu c5: 2 orto t4: 1 orto t4: 2 o c

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

You know the right answer?

8-36 using the batch simulator screen, write a program that will implement the following tank fillin...