Engineering, 03.12.2019 23:31 zitterkoph

Load powerworld simulator case problem 6_46. plot the reactive power output of the generator at bus 2 as a function of its voltage setpoint value in 0.005 p. u. voltage steps over the range between its lower limit of 250 mvar and its upper limit of 50 mvar. to change the generator 2 voltage set point first select tools, play to begin the power flow simulation, and then click on the up/down arrows on the bus 2 magenta voltage setpoint field

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

You know the right answer?

Load powerworld simulator case problem 6_46. plot the reactive power output of the generator at bus...