Engineering, 03.12.2019 19:31 swaggaming941

Acentrifugal compressor is to be used to accelerate a fluid to a tangential mach number of the shaft rotational speed is to be 25,000 the inlet flow condition is characterized by: m1=0.5, =1.4, cp=1,004. size the exit radius of this compressor impeller

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 19:20, lovenahofer

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

continue

Engineering, 06.07.2019 02:30, jayjay5246

Air (c-1.006 kj/kg. k, r-0.287 kj/kg. k) enters a nozzle steadily at 280 kpa and 77°c with a velocity of 50 m/s and exits at 85 kpa and 320 m/s. the heat losses from the nozzle to the surrounding medium at 20°c are estimated to be 3.2 kj/kg. determine (a) the exit temperature and (b) the total entropy change for this process. solve this problem using constant specific heats.

Answers: 1

continue

Engineering, 06.07.2019 04:10, jessicajustice6215

Cold water (cp=4180j/kg k) leadıng to a shower enters a thin-walled double-pipe heat transfer at 15c at a rate of 0.25kg/s and is heated to 45c by hot water (cp=4190j/kg k) that enters at 100c at the rate of 3kg/s. if the overall heat transfer coefficient is 950w /m2 k , determıne the rate of heat transfer and the heat transfer surface area of the heat exchanger using e - ntu method

Answers: 1

continue

You know the right answer?

Acentrifugal compressor is to be used to accelerate a fluid to a tangential mach number of the shaft...