Engineering, 03.12.2019 18:31 cooljariel11

From the numbered list below, decide which of the items are representative of each of parts (a), (b), (c), and ()advantages of cold working.(b)advantages of hot working.(c)disadvantages of cold working.(d)disadvantages of hot working.(1) a high quality surface finish(2) large deformation are possible, which may be repeated(3) the mechanical properties may be varied(4) close dimentional tolerances(5) deformation energy requirements are relatively low(6) a poor surface finish(7) a loss of ductility(8) large deformations must be accomplished in steps, which may be expensive(9) high deformation energy requirements(10) a variety of mechanical properties is not possible(a) - 2,5 (b) - 1,3,4 (c) - 6,8,9 (d) - 7,10(a) - 4,5 (b) - 1,2,3 (c) - 6,9 (d) - 7,8,10(a) - 2,3 (b) - 1,4,5 (c) - 6,7,10 (d) - 8,9(a) - 1,3,4 (b) - 2,5 (c) - 7,8,9 (d) - 6,10(a) - 1,2,5 (b) - 3,4 (c) - 6,10 (d) - 7,8,9

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 19:10, jennymares

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

You know the right answer?

From the numbered list below, decide which of the items are representative of each of parts (a), (b)...