Engineering, 30.11.2019 07:31 blymouton13
1first, compute the integral analytically. then estimate the integral to 6 decimal places, as instructed. a) handwork use multiple applications of the trapezoid rule, with n=6. (use eq. 19.11). b) handwork apply the composite trapezoid rule, with n=6. (use eq. 19.17). c) matlab apply the composite trapezoid rule, with n=6, 12 & 24 d) handwork use multiple applications of simpson’s 1/3 rule, with n=6. (use eq. 19.22). e) handwork apply the composite simpson’s 1/3 rule, with n=6. (use eq. 19.26). f) matlab apply the composite simpson’s 1/3 rule, with n= 6, 12 & 24
Answers: 2
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
1first, compute the integral analytically. then estimate the integral to 6 decimal places, as instru...
Mathematics, 01.04.2020 03:16
Geography, 01.04.2020 03:16
Mathematics, 01.04.2020 03:16