Engineering, 30.11.2019 00:31 lamwil9432

Abalanced bank of delta-connected capacitors is connected in parallel with the load described in assessment problemthe effect is to place a capacitor in parallel with the load in each phase. the line voltage at the terminals of the load thusremains at 2450 v. the circuit is operating at a frequency of 60 hz. the capacitors are adjusted so that the magnitude ofthe line current feeding the parallel combination of the load and capacitor bank is at its minimum. a) what is the size of each capacitor in microfarads? b) repeat (a) for wye-connected capacitorsc) what is the magnitude of the line current? problemthe magnitude of the line voltage at the terminals of a balanced y-connected load is 6600 v. the load impedance is 240 —170 ﬂ/¢. the load is fed from a line that has an impedance of 0.5 + i4 q/¢,a) what is the magnitude of the line current? b) what is the magnitude of the line voltage at the source?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

You know the right answer?

Abalanced bank of delta-connected capacitors is connected in parallel with the load described in ass...