Engineering, 29.11.2019 07:31 euniceyi56

For a bolted assembly with six bolts, the stiffness of each bolt is kb = 2 mlbf/in and the stiffness of the members is km = 14 mlbf/in per bolt. an external load of 80 kips is applied to the entire joint. assume the load is equally distributed to all the bolts. it has been determined to use 1/2 in-13 unc grade 8 bolts with rolled threads. it is desired to ﬁnd the range of torque that a mechanic could apply to initially preload the bolts without expecting failure once the joint is loaded. assume a torque coefﬁcient of k = 0.2.

a. determine the yielding factor of safety.
b. determine the overload factor of safety

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

You know the right answer?

For a bolted assembly with six bolts, the stiffness of each bolt is kb = 2 mlbf/in and the stiffness...