Engineering, 27.11.2019 23:31 grey00

Agas-turbine cycle with two stages of compression (intercooling) and two stages of expansion (reheat) is considered. the inlet air to the first compression stage is at 300 k. the compression efficiency in each stage is 0.8 and expansion efficiency in each stage is 0.85. the compression and expansion ratio in each stage is 3. the air is cooled to its initial temperature after the first compression and is reheated to the maximum temperature after the first expansion. the air is at the temperature of 1200 k leaving the combustor. consider one case without a regenerator and a case with a regenerator with effectiveness of 0.75.a) show the t-s diagram of the cycle. b) determine the back work ratio with and without generator. c) determine the thermal efficiency of the cycle with and without the generator.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

You know the right answer?

Agas-turbine cycle with two stages of compression (intercooling) and two stages of expansion (reheat...