subject
Engineering, 27.11.2019 22:31 o11011195

Consider a non-ideal (e. g. a realistic junction with fermi level pinning) tungsten schottky barrier on silicon having a constant donor density the junction will be a low-resistance ohmic contact that can pass high currents by tunneling if the barrier presented to the electrons is thin enough. we assume that the onset of efficient tunneling occurs when the fermi level extrapolated from the metal meets the edge of the conduction band at a distance no larger than 9 nm from the interface.(a) what is the minimum nd such that this condition would be met at equilibrium? (b) draw a sketch of the energy band diagram under the condition of (a). (c) assume that nd is increased four times from (a). by what factor is the tunneling distance (wdep) reduced? and by what factor is re reduced?

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Consider a non-ideal (e. g. a realistic junction with fermi level pinning) tungsten schottky barrier...

Questions in other subjects:

Konu
Mathematics, 08.03.2021 19:50