subject
Engineering, 27.11.2019 19:31 CrusaderLord

Problem 1if the a-36 steel pipe has an outer diameter of 30 mm and inner diameter of 20 mm, determine the factor of safety against yielding of the material at point a according to the a) maximum-shear-stress theory b) maximum-distortion-energy theoryc) if instead this pipe were made from a brittle, high carbon steel, then determine the factor of safety against yielding for the material at point a using the brittle mohr coulombe (bcm) theory (carbon addition can increase the brittleness of steel). in this case, use tensile strength, σyt= 896 mpa and compressive strength, σyc = 2160 mpa (from matweb).note: we suggest re-working this problem for practice, but you can start this problem with stresses that you determined for the two square stress elements solved for in hw 6.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:20, mercedesamatap21hx0
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
image
Engineering, 04.07.2019 19:20, qurreab26
A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.
Answers: 1
image
Engineering, 04.07.2019 19:20, amcd2002
A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.
Answers: 2
You know the right answer?
Problem 1if the a-36 steel pipe has an outer diameter of 30 mm and inner diameter of 20 mm, determin...

Questions in other subjects: