Engineering, 27.11.2019 03:31 mcqueen10travis

Ashell-and-tube heat exchanger is used for the heating of oil from 20°c to 30°c ; the oil flow rate is 12 kg/s (cp = 2.2 kj/kg* k). the heat exchanger has one shell pass and two tube passes. hot water (cpw = 4.18 kj/kg* k) enters the shell at 75°c and leaves the shell at 55°c. the overall heat-transfer coefficient based on the outside surface of the tubes is estimated to be 1080 w/m2 * k. determine:
a. the corrected logarithmic-mean temperature difference.
b. the required surface area in the exchanger.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

You know the right answer?

Ashell-and-tube heat exchanger is used for the heating of oil from 20°c to 30°c ; the oil flow rate...