Engineering, 26.11.2019 20:31 Dmgirl123

To use the method of superposition to calculate a beam defection and slope.
for beams with small deflections, the assumptions for using the method of superposition apply: the deflections and slopes are linearly related to the load, and the deflections do not significantly change the original geometry of the beam.

the deflections and slopes for beams subjected to multiple loads can then be found using linear combinations of known results for individual loads.

use the two loadings below and the principle of superposition to answer the following questions.

determine the load combination a beam is subjected to the loading shown where w_a = 2 kn/m and w_b = 2.8 kn/m .

describe the loading as a linear combination of the loads in the above table.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Engineering, 04.07.2019 19:20, praveen35301

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

continue

Engineering, 06.07.2019 03:10, iiisavageoreo

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

continue

Engineering, 06.07.2019 03:10, brookealexis5768

Oxygen at 300 kpa and 400 k is in a closed system with an initial volume of 0.1 m3. is now compressed in a polytropic process, with exponent of n 1.2, to a temperature of 500 k. calculate: a) the boundary work done during the compression, in kj b) the heat transfer during the compression, in kj

Answers: 3

continue

You know the right answer?

To use the method of superposition to calculate a beam defection and slope.
for beams with sm...