subject
Engineering, 26.11.2019 19:31 meganwintergirl

Air is heated in a 1-meter-long, 4 mm by 16 mm rectangular duct. the air inlet temperature is 27 °c and the air mass flow rate is 0.0003 kg/s. a uniform heat flux of 600 w/m^2 is imposed on the duct surface. determine the average temperature of the air and the surface temperature of the duct at the duct exit.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, rhussein6452
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
image
Engineering, 04.07.2019 19:10, jrcspiderman2003
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
image
Engineering, 06.07.2019 02:30, chickennbutt0730
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
image
Engineering, 06.07.2019 03:20, 1xXJOKERXx3
Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)
Answers: 3
You know the right answer?
Air is heated in a 1-meter-long, 4 mm by 16 mm rectangular duct. the air inlet temperature is 27 °c...

Questions in other subjects:

Konu
English, 09.01.2020 06:31