Engineering, 23.11.2019 04:31 taylorwhitfield6

An air-standard cycle with constant specific heats at room temperature is executed in a closed system and is composed of the following four processes:
1–2 v = constant heat addition from 14.7 psia and 80°f in the amount of 300 btu/lbm
2–3 p = constant heat addition to 3150 r
3–4 isentropic expansion to 14.7 psia
4–1 p = constant heat rejection to initial state
the properties of air at room temperature are cp = 0.240 btu/lbm·r, cv = 0.171 btu/lbm·r, and k = 1.4.
a. show the cycle on p-v and t-s diagrams. ( upload your response/solution using the controls provided below.) (you must provide an answer before moving on to the next part.)
b. calculate the total heat input per unit mass
c. determine the thermal efficiency

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 19:10, moneyyfletcher

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Engineering, 04.07.2019 19:20, mercedesamatap21hx0

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

continue

You know the right answer?

An air-standard cycle with constant specific heats at room temperature is executed in a closed syste...