subject
Engineering, 22.11.2019 17:31 lilyrockstarmag

If we recreated the scene from fast & furious 7 and dropped a challenger srt® hellcat redeye widebody from a c-130 aircraft at 5,280 ft, how much horsepower would it take to drive past it before it hits the ground if you're 1 mile away? pro tips air density @ sea level, 59 degrees, no wind = p = .002377 slugs/ft^3 coefficient of drag (flat plate, nasa) = c(d) = 1.28 weight = w = 4451 lbs gravitation constant = g = 32.2 ft/sec^2 area = a = 197.5" long x 78.2" wide x (1 ft^2/ 144 in^2) vehicle falls flat, wheels 1st, straight down, at constant acceleration with no aerodynamic drag until terminal velocity horsepower needed to accelerate is average - not peak 100% driveline efficiency

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
image
Engineering, 04.07.2019 18:20, cdyshaylia55
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
image
Engineering, 04.07.2019 19:10, rhiannpelham60
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
You know the right answer?
If we recreated the scene from fast & furious 7 and dropped a challenger srt® hellcat redeye wi...

Questions in other subjects:

Konu
Mathematics, 28.03.2020 01:38