Engineering, 22.11.2019 07:31 alexisger6089
Aturboprop engine consists of a diffuser, compressor, combustor, turbine, and nozzle. the turbine drives a propeller as well as the compressor, delivering a net power of 1.10 mw to the propeller. air enters the diffuser at 8000 m altitude (ta = 236k, pa = 36 kpa) with a velocity of 550 km/h, and decelerates essentially to zero velocity. the compressor pressure ratio is 7.3 and the compressor has an isentropic efficiency of 83%. the turbine inlet temperature is 1360 k, and its isentropic efficiency is 86%. the turbine exit pressure is 10 kpa higher than the ambient pressure at that altitude. flow through the diffuser and nozzle is isentropic. neglect kinetic energy except at the diffuser inlet and the nozzle exit. using an air-standard analysis, determine: a) the mass and volumetric flow rates entering the diffuser, in kg/s and m3/s, respectively. b) the rate of heat addition to the combustor, in mw. c) the velocity at the nozzle exit, in m/s.
Answers: 1
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20, 1230bering
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 19:10, rayne40
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
Aturboprop engine consists of a diffuser, compressor, combustor, turbine, and nozzle. the turbine dr...
Biology, 02.04.2020 17:39
History, 02.04.2020 17:40
Mathematics, 02.04.2020 17:40
Biology, 02.04.2020 17:40
Mathematics, 02.04.2020 17:40