Engineering, 22.11.2019 06:31 wellllm

Let the ends of a copper rod 100 cm long be maintained at 0 degrees celsius. suppose that the center of the bar is heated to over 100 degrees. celsius by an external heat source and that this situation is maintained until a steady state results. find the steady state temperature distribution. at t = 0 [after steady state part (a) has been reached], let the heat source be removed. at that the same instant let the end x= 0 be placed in thermal contact with a reservoir at 20 degree celsius, while the other end remains at 0 degree celsius. find the temperature as a function of time u (x, t).

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, lerasteidl

Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?

Answers: 3

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:20, myahlit84

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

continue

You know the right answer?

Let the ends of a copper rod 100 cm long be maintained at 0 degrees celsius. suppose that the center...