Engineering, 21.11.2019 06:31 Isabella1319

Consider a stainless steel material with a brinnel hardness of 270, that is turned on a lathe. the undeformed chip thickness is 0.25 mm, and the cutting speed is 0.6 m/s. the chip is continuous and a 1- m-long section weighs 5.7 g. the chip width is the same as the workpiece width and equals 1.5 mm. calculate the cutting ratio. assume the density of the stainless steel is 8027 kg/m^3.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

You know the right answer?

Consider a stainless steel material with a brinnel hardness of 270, that is turned on a lathe. the u...