Engineering, 20.11.2019 20:31 colebash88

Acylindrical tank is required to contain a gage pressure 560 kpa . the tank is to be made of a516 grade 60 steel with a maximum allowable normal stress of 150 mpa . if the inner diameter of the tank is 2.6 m , what is the minimum thickness, t, of the wall? part b - maximum pressure for a cylindera cylindrical tank is made of a516 grade 60 steel with a maximum allowable normal stress of 150 mpa . if the inner diameter of the tank is 4.9 m and the thickness is 1.4 cm , what is the maximum allowable gage pressure? part c - spherical pressure vessela spherical pressure vessel is required to contain 1.9 m3 of compressed natural gas at 23 mpa . if the tank is made of a516 grade 60 steel with a maximum normal stress 150 mpa , what is the required thickness of the tank wall?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

You know the right answer?

Acylindrical tank is required to contain a gage pressure 560 kpa . the tank is to be made of a516 gr...