Engineering, 19.11.2019 07:31 Samaritan

In this project you are to compare the runtimes of insertion sort, quick sort and merge sort. you will start will a sorted array of 5 elements. you will execute 10 test runs and calculate the average of the dist value and runtimes of each sorting algorithm. on the first run you will run the sorting algorithms on the sorted array and then store their runtime information in an infonode. for each of the remaining runs you will clone the sorted array and shuffle the cloned array and run the sorting algorithms of the shuffled cloned array and then store their runtime information in an infonode. important, notice for each test run the sorting algorithms are each sorting the same shuffled array. so, you need to copy the shuffle array a couple of times before sorting it.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

You know the right answer?

In this project you are to compare the runtimes of insertion sort, quick sort and merge sort. you wi...