subject
Engineering, 19.11.2019 06:31 Ayori144

Use the ad/as model below to answer the following questions. in each case, assume the economy starts in long- and short-run equilibrium. a. suppose a stock market crash reduces people’s wealth. instructions: drag the appropriate line in the correct direction to show the short-run effect on the ad/as model. this will: increase output and lower the price level. reduce output and lower the price level. reduce output and raise the price level. increase output and raise the price level. b. suppose the government takes no action to the economy. eventually, the price level and output . c. suppose, instead, the government decides to take action to the economy. you can recommend: cutting taxes and/or raising spending. raising taxes and/or cutting spending. cutting taxes and/or cutting spending. raising taxes and/or raising spending. d. if the u. s. government makes the appropriate policy response, what happens to the price level and output in the long run. in the long run, the price level and output .

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, danksans7011
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
image
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Use the ad/as model below to answer the following questions. in each case, assume the economy starts...

Questions in other subjects:

Konu
Engineering, 21.11.2020 02:30