subject
Engineering, 19.11.2019 06:31 jaystarr9395

Cryo-electron tomography uses an electron microscope to obtain remarkably high resolution images, such as those used to understand the structures in planctomycetes bacteria. however, earlier microscopic techniques also led to important discoveries. which of the examples below describes a bacterial characteristic discovered using microscopy? a. electron microscopy has been used to show that mycoplasmas lack cell walls. b. light microscopy with the gram-stain technique has been used to show that bacillus are gram-negative rods. c. electron microscopy has been used to identify the reticulate body in mycobacteria. d. light microscopy and the acid-fast staining technique can be used to distinguish clostridium from all other genera of bacteria.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
image
Engineering, 04.07.2019 18:20, samueltaye
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
image
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
image
Engineering, 04.07.2019 19:10, kelseiroll9759
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
You know the right answer?
Cryo-electron tomography uses an electron microscope to obtain remarkably high resolution images, su...

Questions in other subjects: