Engineering, 19.11.2019 05:31 nyny679
Q2-a three-phase y-a transformer is rated 225-kv: 24-kv, 400 mva and has a series reactance of 6.08 ohms as referred to its high-voltage terminals. the transformer is supplying a load of 375 mva, with 0.89 power factor lagging at a voltage of 24 kv (line-to-line) on its low-voltage side. it is supplied from a feeder whose impedance is 0.17 + j 2.2 ohms connected to its high-voltage terminals. the total load in the system remains constant at 375 mva. a- plot the line-to-line voltage which must be applied to the sending end of the feeder to maintain the load voltage at 24 kv line-to-line for load power factors in range from 0.3 lagging to unity to 0.3 leading. b-plot the sending-end voltage as a function of power factor angle.
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:20, kodyclancy
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
Engineering, 04.07.2019 18:20, sanchez626
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
Engineering, 04.07.2019 19:10, thawkins79
Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj
Answers: 2
You know the right answer?
Q2-a three-phase y-a transformer is rated 225-kv: 24-kv, 400 mva and has a series reactance of 6.08...
Questions in other subjects:
