subject
Engineering, 18.11.2019 23:31 quigley523

Asecond-order mechanical system has the transfer function :

g(s)= 1 = y(s) 0.15s2 + 1.4s + 128 u(s)

the system is initially at rest when a step-input force u(t) = 5u(t) n is applied.

a. show that the transient response will oscillate before reaching a steady-state response.

b. determine the oscillation frequency of the transient response in hz.

c. estimate the number of oscillations (cycles) before the system reaches steady state.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
image
Engineering, 05.07.2019 23:20, neisha2507
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
Asecond-order mechanical system has the transfer function :

g(s)= 1 = y(s) 0.15s2 + 1.4...

Questions in other subjects:

Konu
Social Studies, 16.09.2019 05:00
Konu
Mathematics, 16.09.2019 05:00