Engineering, 14.11.2019 07:31 oofdiegoofdie5562

Aboost converter based power factor correction circuit needs to operate with universal input voltage, i. e the input voltage can be either 120v (rms)+/- 10% at 60 hz or 240 v(rms) +/- 10% at 50 hz. the output voltage is regulated at 400 v dc and the maximum (average) output power is 1kw.

(a) calculate the value of inductance needed to keep its peak-peak ripple current to be less than 10% of the peak fundamental frequency line current at the maximum input voltage and full load condition.

(b) calculate the value of output capacitance needed to keep the peak-peak ripple (at twice the line frequency) to be less than 10% of the nominal output voltage at any operating condition.

(c) calculate the maximum rms ripple current in the output capacitor (neglect switching frequency ripple).

(d) draw over a complete fundamental period corresponding to 240v (rms), 50 hz input.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, aaliyah80

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

Aboost converter based power factor correction circuit needs to operate with universal input voltage...