Engineering, 14.11.2019 02:31 prettyprincess9643

Asource follower is required to connect a high-resistance source to a load whose resistance is nominally 2 k but can be as low as 1.5 k and as high as 5 k. what is the maximum output resistance that the source follower must have if the output voltage is to remain within ±10% of nominal value? if the mosfet has kn = 2.5 ma/v2 , at what current id must it be biased? at what overdrive voltage is the mosfet operating?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, alexis9263

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

continue

Engineering, 04.07.2019 19:20, dndndndnxmnc

The process in which the system pressure remain constant is called a)-isobaric b)-isochoric c)-isolated d)-isothermal

Answers: 3

continue

You know the right answer?

Asource follower is required to connect a high-resistance source to a load whose resistance is nomin...