Engineering, 13.11.2019 22:31 booitsmrradl3385

Problem 7-25 (algorithmic) george johnson recently inherited a large sum of money; he wants to use a portion of this money to set up a trust fund for his two children. the trust fund has two investment options: (1) a bond fund and (2) a stock fund. the projected returns over the life of the investments are 9% for the bond fund and 20% for the stock fund. whatever portion of the inheritance george finally decides to commit to the trust fund, he wants to invest at least 60% of that amount in the bond fund. in addition, he wants to select a mix that will enable him to obtain a total return of at least 8.5%. formulate a linear programming model that can be used to determine the percentage that should be allocated to each of the possible investment alternatives. if required, round your answers to three decimal places. let b = percentage of funds invested in the bond fund s = percentage of funds invested in the stock fund b + s s. t. b bond fund minimum b + s minimum return b + s percentage requirement solve the problem using the graphical solution procedure. if required, round the answers to one decimal place. optimal solution: b = , s = value of optimal solution is %

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, danksans7011

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

You know the right answer?

Problem 7-25 (algorithmic) george johnson recently inherited a large sum of money; he wants to use...