Engineering, 13.11.2019 18:31 hei40563273

Using the following details you conduct pert analysis. the analysis is broken in smaller sub questions. so answering them one by one will complete the analysis. optimistic most likelypessimistic expected variance act no. description time time time time start activity a acti activity c activ 12 10 21 10 17 finish all times as in weeks answer the following questions: calculate the expected time of all the activities including start and finish. calculate variation of all the activities including start and finish. identify the four paths for the network and using your answer 1 and 2 values calculate the expected duration and variance of each path respectively identify the critical path. using the expected duration and variation of only the critical path calculate the probabilities of completing the project in 40 weeks, 42.5 weeks and 48 weeks. 1. 2. 3. 4. 5.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:10, kelseiroll9759

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

continue

You know the right answer?

Using the following details you conduct pert analysis. the analysis is broken in smaller sub questi...