Engineering, 13.11.2019 02:31 ayoismeisjjjjuan

The fire hydrant is tested under a high standpipe pressure. the total flow of 9.8 ft3/sec is divided equally between the two outlets, each of which has a cross-sectional area of 0.031 ft2. the inlet cross-sectional area at the base is 0.57 ft2. neglect the weight of the hydrant and water within it and compute the magnitudes of the tension t, the shear v, and the bending moment m in the base of the standpipe at b. the specific weight of water is 62.4 lb/ft3. the static pressure of the water as it enters the base at b is 118 lb/in.2

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

You know the right answer?

The fire hydrant is tested under a high standpipe pressure. the total flow of 9.8 ft3/sec is divided...