Engineering, 12.11.2019 03:31 ttrinityelyse17

Air enters the compressor of an air-standard brayton cycle with regeneration at 100 kpa and 300 k, with a mass flow rate of 6 kg/s. the compressor pressure ratio is 10 while the turbine inlet temperature is 1400 k. the turbine and compressor each have an isentropic efficiency of 80%, while the regenerator effectiveness is 80%. assuming constant properties evaluated at 300 k determine:

a) the thermal efficiency of the cycle

b) the back-work ratio

c) the net power produced, in kw

d) the rate of entropy generation in the regenerator, in kw/k.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Engineering, 05.07.2019 10:10, johns2380

What is the correct way to measure the overall length of a boat? measure from the tip of the bow to the highest point on the gunwale. measure from the tip of the bow in a straight line to the stern of the boat. measure from the tip of the bow in a straight line to the back seat. measure from port to starboard at the boat's widest point.

Answers: 1

continue

Engineering, 06.07.2019 04:10, johnbobjones

Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump

Answers: 1

continue

You know the right answer?

Air enters the compressor of an air-standard brayton cycle with regeneration at 100 kpa and 300 k, w...