subject
Engineering, 11.11.2019 23:31 madisonmcelvany2404

One hundred electrical components, each dissipating 25 w, are attached to one surface of a square (0.2 m 0.2 m) copper plate, and all the dissipated energy is transferred to water in parallel flow over the opposite surface. a protuberance at the leading edge of the plate acts to trip the boundary layer, and the plate itself may be assumed to be isothermal. the water velocity and temperature are u 2 m/s and t 17 c, and the water’s thermophysical properties may be approximated as 0.96 106 m2 /s, k 0.620 w/m k, and pr 5.2. ch007.qxd 4/14/11 8: 23 pm page 471

(a) what is the temperature of the copper plate?

(b) if each component has a plate contact surface area of 1 cm2 and the corresponding contact resistance is 2 104 m2 k/w, what is the component temperature? neglect the temperature variation across the thickness of the copper plate.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, aliopqwas
Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.
Answers: 1
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
One hundred electrical components, each dissipating 25 w, are attached to one surface of a square (0...

Questions in other subjects: