Engineering, 11.11.2019 19:31 ash3246

The tool move from (0,0) to (0, 3.5) and then continue to finish the while profile. the tool diameter is store in register d12. use absolute movement g90. to program this part profile, use the .750 diameter end mill, starting at lower left hand corner. use cutter compensation, and climb cut part profile with only one finish pass .450 deep. use feedrate of 10 inch/min for cutting. tool 12 – ¾ dia. 4 flt. end mill; surface speed (fpm) = 275.; chip per flute: .0025

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, Doogsterr

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

continue

Engineering, 04.07.2019 19:10, ultimateapes

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

continue

You know the right answer?

The tool move from (0,0) to (0, 3.5) and then continue to finish the while profile. the tool diamete...