subject
Engineering, 11.11.2019 18:31 annethelusma25

Atwo-stage compression refrigeration system operates with refrigerant-134a between the pressure limits of 1 and 0.14 mpa. the refrigerant leaves the condenser as a saturated liquid and is throttled to a flash chamber operating at 0.5 mpa. the refrigerant leaving the low-pressure compressor at 0.5 mpa is also routed to the flash chamber. the vapor in the flash chamber is then compressed to the condenser pressure by the high pressure compressor, and the liquid is throttled to the evaporator pressure.

assuming the refrigerant leaves the evaporator as saturated vapor and both compressors are isentropic, determine

(a) the fraction of the refrigerant that evaporates as it is throttled to the flash chamber,

(b) the rate of heat removed from the refrigerated space for a mass flow rate of 0.25 kg/s through the condenser, and (c) the coefficient of performance.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 03:10, lauriepdx17
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Atwo-stage compression refrigeration system operates with refrigerant-134a between the pressure limi...

Questions in other subjects: