Engineering, 10.11.2019 02:31 Skye251

Atank initially contains 12.5 kg water at 2 bar and the quality is 65%. the tank is connected to a steam pipe with a valve and initially the valve is closed. the pipe is carrying steam at 15 bar and 240°c. the valve is then opened until the until the tank pressure reaches 7 bar, at which time the valve was closed, and the tank temperature has reached 200°c.
(a) determine the volume of the tank in cubic meters.
(b) determine the final mass in kg.
(c) determine the heat transfer between the water in the tank and its surroundings (in kj) that occurred while the valve was open. tea m 15bar 2400 va\ve ,q=? tank

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

You know the right answer?

Atank initially contains 12.5 kg water at 2 bar and the quality is 65%. the tank is connected to a s...