Engineering, 09.11.2019 04:31 Adreanna1018

Motor 1 is producing 22 hp at 3450 rpm. torque loads of 57ft⋅lb57ft⋅lb, 179ft⋅lb179ft⋅lb, and 67ft⋅lb67ft⋅lb are being driven at a, c, and d, respectively. the dimensions of shaft abcde (which has concentric solid circular cross-sections and a modulus of rigidity of 10.3 mpsi) are given below. assuming no losses in the system, find: (i) the torque, power, and angular velocity being produced by motor 2. (ii) the maximum torsional stresses and the angles of twist in each segment of shaft abcde (iii) the overall maximum torsional shear stress and the overall angle of twist between a and e.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

You know the right answer?

Motor 1 is producing 22 hp at 3450 rpm. torque loads of 57ft⋅lb57ft⋅lb, 179ft⋅lb179ft⋅lb, and 67ft⋅l...