Engineering, 08.11.2019 05:31 20vmiller

Two containers, x and y, both contain nitrogen gas at a temperature of 30° c and a pressure of 1 atm. the initial volume of each of the containers is v30 = 0.5 liters. the only difference between the two containers is that while container x has a piston that is sealed and cannot move, the gas in container y is allowed to expand against the surrounding atmosphere. qx is the amount of heat required to raise the temperature of the gas in container x by 10° c, and qy is the amount of heat required to raise the temperature of the gas in container y by 10° c. what is the difference between qx and qy? use 0°c = 273.15 k qx - qy =

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

Engineering, 06.07.2019 03:20, harleyandpope90

Aparticle moves along a straight line such that its acceleration is a=(4t^2-2) m/s, where t is in seconds. when t = 0, the particle is located 2 m to the left of the origin, and when t = 2, it is 20 m to the left of the origin. determine the position of the particle when t=4s.

Answers: 1

continue

You know the right answer?

Two containers, x and y, both contain nitrogen gas at a temperature of 30° c and a pressure of 1 atm...