Engineering, 05.11.2019 22:31 KarrieShea42

A10 cm x 10 cm circuit board dissipating 10 w of power uniformly is cooled by air, which approaches the circuit board at 15°c with a velocity of 4 m/s. disregarding any heat transfer from the back surface of the board, determine the surface temperature of the electronic components at the end of the board. determine the surface temperature of the electronic components (a) at the leading edge and (b) at the end of the board. assume the flow to be turbulent since the electronic components are expected to act as turbulators. assume a film temperature of 27°c.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

You know the right answer?

A10 cm x 10 cm circuit board dissipating 10 w of power uniformly is cooled by air, which approaches...