Engineering, 05.11.2019 05:31 tyrique86

Acomposite floor system consists of w18 x 97 beams and a 5-inch-thick reinforced concrete
floor slab. the span length is 30 feet, and the beams are spaced at 8 feet. in addition to the
weight of the slab, there is a construction load of 20 psf. a uniform live load of 800 psf is
expected during the life of the floor. assume that there is no support during the construction
phase. a992 steel is used, and normal weight concrete is used (we = 145 ). the 28-day
compressive strength of concrete is f' = 4 ksi.
a) compute the total stress at the bottom of steel and the stress at the top of concrete.
b) determine the flexural strength of the composite section.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 19:10, moneyyfletcher

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

continue

Engineering, 06.07.2019 02:30, emiller6462

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

continue

You know the right answer?

Acomposite floor system consists of w18 x 97 beams and a 5-inch-thick reinforced concrete
floo...