subject
Engineering, 05.11.2019 00:31 kymmyaboss2

Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h, and 3.00% s. analysis of the furnace exhaust gas shows only n2, o2, co2, so2, and h2o. the sulfur dioxide emission rate is to be controlled by passing the exhaust gas through a scrubber in which most of the so2 is absorbed in an alkaline solution. the gases leaving the scrubber (all of the n2, o2, and co2, and some of the h2o and so2 entering the unit) pass out to a stack. the scrubber has a limited capacity, however, so that a fraction of the furnace exhaust gas must be bypassed directly to the stack. at one point during the operation of the process, the scrubber removes 90.0% of the so2 in the gas fed to it, and the combined stack gas contains 634.5 ppm (parts per million) so2 on a dry basis; that is, every million moles of dry stack gas (i. e. not including the water) contains 634.5 moles of so2. we wish to calculate the fraction of the exhaust bypassing the scrubber at that moment.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Afuel oil is fed to a furnace and burned with 25.0% excess air. the oil contains 87.0 wt% c, 10.0% h...

Questions in other subjects: