Engineering, 02.11.2019 05:31 azeezat728

Air enters a compressor at 14.7 psia and 70°f. the inlet volumetric flow rate is 16.6 ft3/s and the flow area is 0.26 ft. the air exits at 35 psia with a velocity of 50 ft/s. the power input is 100 hp. heat transfer from the compressor to its surroundings is 1.0 btu per lbm of air flowing. assume steady state operation, negligible potential energy effects, and ideal gas behavior. determine: a. velocity of the air at the inlet [ft /s] b. mass flow rate of air [lbm/s) c. compressor exit temperature (°f). d. change in kinetic energy across compressor (btu/lbm) and compare with change in enthalpy

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

You know the right answer?

Air enters a compressor at 14.7 psia and 70°f. the inlet volumetric flow rate is 16.6 ft3/s and the...