Engineering, 01.11.2019 05:31 judyandaub1
Consider fe – 3.0 wt% c steel at a temperature just below the eutectic point. determine the phase present in this alloy. determine the compositions of each phase. determine the relative amount of each phase. determine the relative amount of lamellar structure. determine the relative amount of lamellar structure.
(e) consider 10 kg of fe – 1.0 wt% c steel at 1200°c. how much pure iron pellets should be added to this steel to have pearlite only in its microstructure when the temperature is decreased below the eutectoid point slowly?
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20, karatsgrande3772
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
Consider fe – 3.0 wt% c steel at a temperature just below the eutectic point. determine the phase pr...
Questions in other subjects:
