Engineering, 29.10.2019 06:31 gabby640

A3-mm-diameter electrical wire is insulated by a 2-mm-thick rubberized sheath (k = 0.13 w/m·k), and the wire/sheath interface is characterized by a thermal contact resistance of r, e=3x1 convection heat transfer coefficient at the outer surface of the sheath is 15 w/m2 . k, and the temperature of the ambient air is 20°c. if the temperature of the insula- 0-4m2. k/w. the tion may not exceed 50'c, what is the maxtimun allow- able electrical power that may be dissipated per unit length of the conductor? what is the critical radius of the insulation?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 06.07.2019 03:10, betru12315

How to convert a friction to decimal ?

Answers: 1

continue

You know the right answer?

A3-mm-diameter electrical wire is insulated by a 2-mm-thick rubberized sheath (k = 0.13 w/m·k), and...