subject
Engineering, 25.10.2019 03:43 mmoufak29

Air at 0.25 bar absolute pressure, 220 k temperature, and velocity 300 m/s (state 1) steadily enters the diffuser of a turbojet engine. air exits from the diffuser at an absolute pressure of 0.48 bar and negligible velocity (state 2). air exiting the diffuser then enters a low-pressure compressor (lpc) where it is compressed to 2.63 bar absolute pressure and 400 k temperature (state 3). air leaving from the lpc flows into a heat exchanger which cools the air to a temperature equal to that at the exit of the diffuser (t4t) heat transfer occurs at the rate of 6805 kw from the heat exchanger to its surroundings. air leaving from the heat exchanger enters a high-pressure compressor (hpc) and it is compressed to 14.4 bar absolute pressure and 400 k temperature (state 5) (a) calculate the temperature (k) of air at the exit of the diffuser. (b) determine the mass flow rate (kg/s) of air through the engine (c) find the total power input (kw) for the lpc and hpc. (d) what is the area (m') and the corresponding diameter (ft) of the diffuser inlet section?

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:10, qwertylol12345
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
You know the right answer?
Air at 0.25 bar absolute pressure, 220 k temperature, and velocity 300 m/s (state 1) steadily enters...

Questions in other subjects:

Konu
Mathematics, 12.07.2019 01:00