Engineering, 25.10.2019 01:43 ARAYAMYHAND

Athermocouple, with a spherical junction diameter of 0.5 mm, is used for measuring the temperature of hot air flow in a circular duct. the convection heat transfer coefficient of the air flow can be related with the diameter (d) of the sphere and the average air flow velocity (v) as h = 2.2(v /d)0.5, where d, h, and v are in m, w/m2•k, and m/s, respectively. the properties of the thermocouple junction are k = 35 w/m•k, rho = 8500 kg/m3, and cp = 320 j/kg•k. the maximum response time of the thermocouple to record 78 percent of the initially applied temperature difference is 5 s. determine the minimum air flow velocity that the thermocouple can be used.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

You know the right answer?

Athermocouple, with a spherical junction diameter of 0.5 mm, is used for measuring the temperature o...