Engineering, 24.10.2019 03:00 sherlyndaniel89

Write a c program that will use the circular doubly linked list.
x-kingdom has trapped n number of soldiers of their opponent. they want to execute them. they found out a strategy so that the prisoners will kill each other and at the end one prisoner will be alive and he will be released. as part of the process, they labeled each trapped soldier a sequence number starting from 1 and ending at n. so, all the n number of prisoners standing in a circle waiting to be executed. however, one soldier was distracting the sequence and it was found out that they were standing in reverse order instead of proper order like the following (lets say n = 7):

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 19:20, rida10309

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

continue

Engineering, 06.07.2019 02:30, khalilh1206

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

continue

Engineering, 06.07.2019 03:10, LouieHBK

Different between right hand turning tool and left hand turning tool ?

Answers: 1

continue

You know the right answer?

Write a c program that will use the circular doubly linked list.
x-kingdom has trapped n numb...