Engineering, 23.10.2019 20:30 makaileep1623

1. what problems are to occur if a concrete has too low of a slump? 2. explain the differences between reinforcing and prestressing and the relative advantages and disadvantages of each. 3. what are control joints and isolation joints? explain the purpose and typical locations of each in a concrete slab. 4. explain the role of stirrups in beams. 5. why are precast concrete structural members usually cured with steam? 6. describe the following key terms and concepts: a. self-consolidated concrete b. lift-slab construction c. column tie d. waffle slab e. double tee

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Engineering, 04.07.2019 19:20, amandaaarmentaa

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

continue

Engineering, 06.07.2019 03:30, carolina1636

The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.

Answers: 2

continue

You know the right answer?

1. what problems are to occur if a concrete has too low of a slump? 2. explain the differences betw...