Engineering, 23.10.2019 18:00 anthonybowie99
Indicate when each of the following bindings takes place in c++ (language design time, language implementation time, compile time, link time, load time, or run time). if more than one time is possible, choose the latest possible time. a. binding of the long int type to a specific number of bytes (i. e., the decision to use a specific number of bytes to store a long int value) b. binding of a variable declared outside a function to a specific memory address c. binding of the char type to a specific set of values d. binding of an operator to a specific number of operands e. binding of a static variable inside a method
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:20, Doogsterr
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
Engineering, 04.07.2019 19:20, littlepotato10
To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.
Answers: 1
Engineering, 06.07.2019 02:30, heavenwagner
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
You know the right answer?
Indicate when each of the following bindings takes place in c++ (language design time, language impl...
Questions in other subjects:
History, 11.06.2020 06:57
History, 11.06.2020 06:57
