The 30 degree vertical bend in a pipe with a 2 ft diameter
carries water (rho = 62.4 lbm...
Engineering, 23.10.2019 01:50 joejoefofana
The 30 degree vertical bend in a pipe with a 2 ft diameter
carries water (rho = 62.4 lbm/ft^3) at a rate of 31.4 cfs. if the
pressure p1 is 10 psi at the lower end of the bend, where the
elevation is 100 ft, and p2 is 8.5 psi at the upper end, where the
elevation is 103 ft, what will be the vertical component of force
that must be exerted by the "anchor" on the bend to hold it in
position? the bend itself weighs 300 lb, and the length l is 4
ft.
Answers: 2
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:10, Tyrant4life
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
History, 26.06.2019 07:00
Biology, 26.06.2019 07:00
Chemistry, 26.06.2019 07:00
History, 26.06.2019 07:00