![subject](/tpl/images/cats/User.png)
Engineering, 19.10.2019 04:20 janetcooly
We use the stop and wait arq protocol between a sender and receiver. the transmission line that connects them has 50ms one-way propagation delay. taking all factors into account, the sender timeout is set to 140ms, and the system is working properly under these conditions. we observe now, however, that the channel has changed, and its one-way propagation delay has grown to 70ms. how much should be the new sender timeout, if there is no other change in the system? the timeout parameter should remain the same. the reason is that we consider a data link layer protocol, which does not have to deal with physical layer parameters, such as the propagation delay. due to 20ms increase in the propagation delay, the timeout should also increase with the same amount, since the other parameters, such as processing time, did not change. the new timeout parameter should be set to 180ms.
![ansver](/tpl/images/cats/User.png)
Answers: 1
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, niicoleassssssf
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
We use the stop and wait arq protocol between a sender and receiver. the transmission line that conn...
Questions in other subjects:
![Konu](/tpl/images/cats/mat.png)
Mathematics, 25.03.2021 09:10
![Konu](/tpl/images/cats/fizika.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 25.03.2021 09:20
![Konu](/tpl/images/cats/en.png)
English, 25.03.2021 09:20
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/himiya.png)
Chemistry, 25.03.2021 09:20
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/biologiya.png)
![Konu](/tpl/images/cats/es.png)
![Konu](/tpl/images/cats/obshestvoznanie.png)
Social Studies, 25.03.2021 09:20